2-6-6-6 Allegheny
|
Any 1" or shorter decoder with our "PR"
NMRA harness. NOTE: This loco (at least the first
run) is known to have wiring problems. You would be wise to make sure
your loco is wired correctly before plugging a decoder in and test
running it. Also, the tender light is powered from only one rail (half-wave)
with a single diode in the tender. You can provide full-wave power
by adding another diode from the other rail power pickup. Connect
the striped end of the diode to the striped end of the existing diode.
Connect the other end of the diode (with a wire) to power pickup from
the opposite rail that the existing diode is connected to.
|
No recommendations.
|
| 2-8-8-2 Mallet |
Any wired
decoder. More difficult and time-consuming than usual for decoder
installation. |
TUX12
and 3/4" speaker in boiler. |
| 4-6-6-4 Challenger |
Any wired
decoder, in boiler. |
TUX10
and any speaker in the tender. |
