• 1.25-amp continuous motor drive, 2-amp peak motor drive
• Two- and Four-Digit Addressing
• Speed Steps: 14, 28, and 128
• Switching Speed
• Momentum: Acceleration and Deceleration
• V-Start, V-Mid, and V-Max in All speed-step modes
• Base-Direction Programming
• User Identifiers
• User-Loadable Speed Table
• Forward and Reverse Trim for the User-Loadable Speed Table
• Kick Start for the User-Loadable Speed Table
• Decoder-Assisted Consisting
• DAC Function Control
• DAC Momentum Trim
• DC Analog Conversion
• Six 500 mA Functions; yes, 1/2-amp, but remember, 2 amps maximum for motor drive and functions
• Full-Wave (Blue Common) Wiring
• Directional/Non-Directional Lighting
• FX Lighting:

Random flicker (for steam fire-boxes)
Mars light
Flashing Headlight
Single-pulse strobe
Double-pulse strobe
Rotary beacon
Gyralite
Rule 17 Dimmable headlight (dims when Function 4 is turned on or loco direction is opposite)
FRED
Blinking Ditch Lights (starts blinking when Function 2 [the horn button] is pressed).

NOTE: Programming these effects into Functions 3 and 4 requires a system and throttle capable of programming CVs > 99.

• Master Switch
• Service-Mode Programming, all forms
• OPS-Mode Programming
• OPS-Mode Read-Back (if your layout is wired for Transponding)
• Back-EMF Control
• SuperSonic Drive
  NOTE: As with any "quiet drive"-type decoder, any capacitor across the loco's motor leads must be disconnected!
• Torque Compensation
• Function Remapping
• Transponding
• CV Reset
• Short-Circuit Protection
• Thermal Protection
• Programming Lock